![]() Battery is above or below normal operating temperature. The following charts detail the Scanner and Cradle LED definitions. If you reboot the PC and the green light appears on the scanner cradle before Windows finishes booting up and then turns off again, try scanning the HID USB host-type barcode below while the computer is booting up and the green light is still appearing on the cradle. If you are unable to scan any of the barcodes above try printing the LI4278 Quick Start Guide.Ĭradle has no light but temporarily presents a light when the PC is rebooted If you can't scan large cartons or case barcodes please scan this barcode to activate. To add an Enter key after scanned data, please scan all three bar codes in numerical order. Update the scanner's firmware by downloading the 123 Scan UtilityĪDD AN ENTER KEY: (Carriage Return/Line Feed).Scan the Set Factory Defaults barcode (below) followed by the Add an Enter Key barcodes in sequence.You will need a Philips head screwdriver to disconnect the battery. Disconnect the battery from the bottom of the barcode scanner temporarily and then plug it back in.After the LI4278 resets release the trigger and remove it from the cradle.While resetting the scanner should emit power-up beeps.A red led light should start blinking on the LI4278 signalling that it started re-initialising/resetting.Pull and hold the LI4278 trigger for approximately 20-30 seconds.Disconnect the cradle cable from the PC end and plug it into a different USB port.The cable has an end like a telephone cable with a plastic clip. Disconnect the cable at the bottom of the cradle.Note Between each step please try scanning a product barcode to see if the issue has been resolved. ![]() The steps below regard the models LS4278 or LI4278. If the scanner beeps 3 times after an unsuccessful scan then please complete the steps below to troubleshoot your device. ![]() If the scanner loses power after scanning a barcode and is more than two years old then the battery may need replacing which we can supply. You're now ready to scan and sell items to your customers with your barcode scanner.If your wireless barcode scanner is not scanning properly it might be due to a low battery or it might require troubleshooting. The scanner will display as connected at the top of the screen and on the Profile screen. Now that your barcode scanner is paired to your iPad, test it by scanning an item in the Retail POS app. Its blue Bluetooth LED light also flashes slowly. Once the pairing process is complete, your barcode scanner displays as Connected under MY DEVICES. Under OTHER DEVICES, tap your barcode scanner.In the Bluetooth panel, enable the Bluetooth switch.The barcode scanner will beep and its Bluetooth LED light will start flashing quickly. To do so, scan the barcode below directly from your iPad's screen. To use your barcode scanner and keyboard at the same time in the Retail POS app, you need to set it to Bluetooth MFi_SSI mode. By default, your barcode scanner is set to the HID keyboard mode.To reset your barcode scanner to factory defaults, scan the barcode below directly from your iPad's screen:Ģ. Pair your barcode scanner with your iPad.Under MY DEVICES, tap the information icon to the right of your barcode scanner.On your iPad, tap Settings > Bluetooth.Reset your barcode scanner to factory defaults If you do, however, make sure to not stretch them in the printing process as it'll make it unscannable. The barcodes are also included in Zebra's CS4070 Scanner Product Reference Guide that came with your barcode scanner.ġ. Note: If scanning the barcodes in this setup directly from your iPad's screen doesn't work, try printing this Help article and scanning the printed copy of the barcodes instead. Pair your barcode scanner with your iPad.Reset your barcode scanner to factory defaults.If you're having issues pairing your Zebra CS4070 barcode scanner to your iPad: ![]()
0 Comments
Leave a Reply. |